Sunday, May 26, 2013
Drag car showroom with his own hands
Shifting his saloon car rukamiOchen often motorists are facing the same problem as pollution saloon car, in which case it is not accurate is not hygienic. If cleaning does not help you in this case, the experts on this part are advised to change the upholstery. This article will help you make the constriction with their hands. Always begins with a waist ceiling. The first step is to detach all the visors, caps and pens (do it very carefully, because the plastic eventually might just burst). Under all these parts are bolts that hold the trim and attached to the ceiling. As it is necessary to unfasten the lamp and clip in the passenger compartment. After removing the lamps, you'll see the connector mom-dad, otstegnite it. Under the decorative overlays, plastic sheathing is, they just need to detach. After completion of the work, described earlier, you should pull the trim through the open trunk lid. You should wrap the edges of lining, and to secure the necessary glue masking tape. Special knife for cutting linoleum, make a hole for a lamp fixing tape. Then you need to fix cladding to the right place, then all the plugs and handles set into place. In the same way can update skin seats and carpets, luggage. Of course, more expensive to buy new chairs, you can buy them blankets, which would have approached them. A door trim and armrests can be done independently, it will be easier and cheaper. Job better start with the doors. Well, take a glue, a screwdriver and a variety of cloth, which you want to trim, (screwdriver worth taking a folded 90 degrees at the end). In the beginning you need to remove the old trim and clean the door. After which route the fabric to the door, and cut it on a path, do not forget to cut out the contours of the door handle. Use a screwdriver to tuck the fabric. Draw the junction of the exact contour of the door casing, and straighten the fabric, leaving allowances. Along the contour of the door, apply some glue and a screwdriver to tuck the fabric. That there were no wrinkles, flatten and pull the fabric. Hole for the window lifter, do this: By selling cloth and carefully cut it, what would fold the edges and glue a face on the other side. With lining the front doors do the same. Then you can start making constriction armrest. First, remove the armrest from the seat, disassemble and make patterns. Patterns can be created by applying an armrest for tracing, looking around the path. After which the tissue using patterns draw the parts with allowances. With scissors, cut out parts, do the fitting. Originally Sew seams bottom of the armrest and pull the fabric gently at him, smoothing the folds. Glue the fabric around the contour. Just steps from the upper part of the armrest. Assemble and install the armrest in place.
